feat(linux): Update CPSW PTP switch mode documentation

CPSW Switch mode can also be tested where DUT acting as a Switch can be a
master of DUTs connected to it. Update the documentation to include that.

Signed-off-by: Chintan Vankar <[email protected]>

Author: chintanv133

source/linux/Foundational_Components/Kernel/Kernel_Drivers/Network/CPSW-PTP.rst

@@ -1068,3 +1068,9 @@ On J7VCL:
    ptp4l[447.707]: master offset      15459 s2 freq   -2401 path delay    180152
    ptp4l[448.707]: master offset        256 s2 freq  -12966 path delay    180152
    ptp4l[449.707]: master offset      -4951 s2 freq  -18096 path delay    180152
+
+.. note::
+
+   Switch Mode can also be tested in a configuration where the DUT acts as a master
+   and DUTs connected to it acting as slaves. The setup and commands will be the
+   same as those used for ICSSG. For further details, refer to :ref:`icssg_ptp_switch`.

source/linux/Foundational_Components/PRU-ICSS/Linux_Drivers/PRU_ICSSG_Ethernet_Switch.rst

@@ -167,6 +167,8 @@ To disable cut through on all queues
     expected cut through value. Setting up switch mode will automatically stop and start
     the firmware so no need to bring links down and back up again.
 
+.. _icssg_ptp_switch:
+
 PTP
 """
 PTP can be run during switch mode. To run PTP in switch mode, 3 AM64x EVMs need to be connected with middle EVM acting as the switch. Use the following ptp config file on all slave EVMs. For Master EVM, priority1 filed needs to be changed.